Why B.C. and Alaska avoided a massive tsunami - Hallo friendsGOOD OF CONEX NEWS, In the article you read this time with the title Why B.C. and Alaska avoided a massive tsunami, We have prepared this article for you to read and retrieve information therein. Hopefully the contents of postings Article health, Article news, Article sport, Article tips, Article treatment, We write this you can understand. Alright, good read.

Title : Why B.C. and Alaska avoided a massive tsunami
link : Why B.C. and Alaska avoided a massive tsunami

Why B.C. and Alaska avoided a massive tsunami

Coastal communities in British Columbia and Alaska were evacuated to higher ground early this morning after tsunami warning sirens blared following a large earthquake off the coast of Alaska. But the warning was later cancelled without any reported tsunami damage. Why?

Tsunamis are giant waves — up to 30 metres high — generated by large earthquakes, and can cause massive damage. The 2004 Boxing Day tsunami in the Indian Ocean killed more than 200,000 people. More recently, a massive earthquake and tsunami in Japan in 2011, caused major damage and a meltdown at the Fukushima nuclear power plant.

Tuesday's earthquake struck at 1:31 a.m. PT in the Pacific Ocean about 250 kilometres southeast of Chiniak, Alaska. The U.S. Geological Survey initially reported the quake's strength at 8.2 and later revised that to 7.9, with a depth of 25 kilometres. At least three aftershocks were reported.

Earth is comprised of moving slabs of rock called plates. Areas where they meet are called fault lines. When these move against each other we get earthquakes.

A map illustrates all the tectonic plates on Earth. (Wikimedia/USGS/Kayau)

According to the International Tsunami Information Centre, the most destructive tsunamis are generated from large, shallow earthquakes — those with a magnitude higher than 7.5 and less than 70 kilometres deep — with an epicentre or fault line near or on the ocean floor.

Tuesday's earthquake met those criteria.

But the type of earthquake also matters, reports CBC seismologist Johanna Wagstaffe.

She said the quake struck in an area where there is a transition between two types of earthquakes:

• Strike-slip, where two tectonic plates slide horizontally past each other.
• Megathrust, where one plate slides under the other, also called subduction.

"This kind of earthquake was what is called a strike-slip earthquake," Wagstaffe said. "That means there isn't as much vertical displacement. So when you're thinking of these rocks on the ocean floor, it didn't punch up like some other earthquakes have."

Instead of the water being displaced upward and forward, this water was moved much less by the horizontal motion. A fortunate circumstance for anyone living along the coast.

In the case of the 2004 and 2011 earthquakes, there was more vertical motion, which had devastating consequences. Roughly 225,000 were killed in the 2004 earthquake; 20,000 people were killed in Japan in 2011.

Motion of the plates

The West Coast is an area with quite a few fault lines that can result in various motions, Wagstaffe explains.

"Where the Gulf of Alaska curves, you end up getting a splay of fault lines," she said. "There's a really interesting section where this earthquake occurred where you can get all different kinds of motion happening. If it had've occurred 90 kilometres to the west then it would have been a subduction earthquake and we could have seen a massive tsunami."

In a megathrust earthquake, the plates move vertically, while in a strike-slip earthquake the plates move horizontally.

And it's not without precedent.

On March 27, 1964, a 9.2 magnitude earthquake occurred off the coast of Alaska at a depth of 25 kilometres. Rather than being a strike-slip, it was a megathrust and produced a tsunami that rose 30 metres in some areas, killing more than 130 people.

In this March 1964 photo released by the U.S. Geological Survey, tsunami damage is shown along the waterfront in Kodiak, Alaska. The 9.2 magnitude quake hit at 5:30 p.m. Good Friday, turning soil beneath parts of Anchorage into jelly and collapsing buildings that were not engineered to withstand the force of colliding continental plates. (USGS/AP)

"This is a reminder that we live in a seismically active area of the world.… It's also a reminder that we get different kinds. We're waiting for the 'Big One,' but we could also get a smaller earthquake, shallower closer to a major city. That would be devastating."

Wagstaffe said the West Coast can expect after shocks over the next few days or even weeks. 

For now, seismologists will gather data collected from the earthquake to better understand the risks along the West Coast. 

"We are quite vulnerable to a lot of different earthquake risks here."

Let's block ads! (Why?)

Thus Article Why B.C. and Alaska avoided a massive tsunami

That's an article Why B.C. and Alaska avoided a massive tsunami This time, hopefully can give benefits to all of you. well, see you in posting other articles.

You are now reading the article Why B.C. and Alaska avoided a massive tsunami with the link address https://coneknews.blogspot.com/2018/01/why-bc-and-alaska-avoided-massive.html

Tweet

Subscribe to receive free email updates: